Enlish


We need:
eWinloader1.1.2c.exe (sometimes called ApplicationLoader.exe, do not know why smb rename file)
Miniloader_p2o.urt

If you need to return back to original software in the SRT6 then proceed with following steps:
- make sure that TV set is connected to the receiver. You will need to control process on TV set screen.
- connect PC and receiver by null-modem cable
- turn receiver to update mode (hold CH Down button on front panel while connect receiver to the mains)
- on PC run eWinloader1.1.2c. Press "Connect" button (or shortcut Ctrl+N) on the tool bar. If receiver connected not to the COM1 you will be noticed about this. Make sure to select correct COM port.
- once connection established press "Upload data from PC to STB" button (or short cut F3) on the tool bar.
- in dialog box select file Miniloader_p2o.urt and press "Open" button.
- update process will start. You will see progress bar on TV screen and on your PC.

Once uploading finished receiver will reboot with backup copy of boot first (you will see screen DCU181 mnldr 1.0 screen saying "Erasing OLD boot strap").
After erasing old boot receiver will reboot again with original boot version 4.7.5bs. 
Now you can load original application using standard SerialTranxx tool.

Success,
Jan de Backer ;)



In Russian
 

             .
     com .
 :
eWinloader1.1.2c.exe (    ApplicationLoader.exe.       ).
Miniloader_p2o.urt

:
-    .       .
-      - 
-       (     CH Down    )
-   eWinloader1.1.2c.      "Connect"    Ctrl+N.       COM1,             .   .
-     "Upload data from PC to STB"        F3. 
-      Miniloader_p2o.urt    "".
-    .           .

        .       DCU181 mnldr 1.0   "Erasing OLD boot strap".           version 4.7.5bs.
        .

Jan de Backer
